Home/Standards

ASTM A416 vs GB/T 5224: what actually differs

Most of the disagreement is in the names, not the steel. A 15.2 mm strand at 1860 MPa and a 0.6 in strand at Grade 270 are the same product; the differences are in diameter rounding, test reporting and which certificate your engineer will accept.

Side by side

ItemASTM A416 / A416MGB/T 5224-2023
Strength designationGrade 270 (270 ksi = 1860 MPa), 250 (1725 MPa)1860 MPa, 1770 MPa, 1720 MPa
Common diameters0.500 in (12.7 mm), 0.600 in (15.24 mm), 0.620 in (15.7 mm)12.7, 15.2, 15.7, 17.8, 21.6 mm (1×7)
Minimum breaking load, 15.2 mm class260.7 kN for 0.600 in260.4 kN for 15.20 mm (140 mm² × 1860 MPa)
Relaxation limit2.5% at 70% of breaking load, 1,000 h (low relaxation)2.5% at 70%, 1,000 h
Elongation at maximum loadNot less than 3.5%Not less than 3.5%
CertificateMill test certificate, often requested as EN 10204 3.1产品质量证明书 (batch quality certificate), per coil
Typical useUS-specification and international projects, Pakistan in practiceChinese-designed projects, domestic mills' default

Values are the standard requirements as normally quoted; the certificate for your batch is the governing document. Dimension rounding (15.20 vs 15.24 mm) does not change the nominal area materially — both are 140 mm² class.

The three differences that matter in practice

1. Diameter naming

ASTM sizes come from inches: 0.600 in = 15.24 mm, which the Chinese standard rounds to 15.20 mm. Both are 140 mm². If your drawing says 15.24 mm and the certificate says 15.20 mm, nobody is cheating — it is the same wire arrangement, measured under a different convention.

2. What the certificate reports

An ASTM-style mill certificate typically lists breaking load, yield, elongation and modulus per heat. A Chinese batch certificate lists the same values but per coil, with the batch and heat number, and often adds relaxation measured over 1,000 hours. For a buyer, the Chinese format is arguably more traceable; for a consultant checking against A416, the ASTM wording is easier to accept. We can issue either.

3. What your engineer will accept

This decides it. If the specification says ASTM A416 Grade 270 and the consultant will reject a GB certificate, order to ASTM and let the mill certify to ASTM. If the project is Chinese-designed or the consultant accepts GB/T 5224, order to GB — it is normally cheaper and faster because it is the mill's default run.

What we recommend for Pakistan

Most Pakistani bridge and building specifications are written to ASTM A416 Grade 270, so we default to ASTM for those enquiries and to GB/T 5224 where the consultant accepts it. Either way the physical product comes off the same line; only the certificate and the inspection routine change.

If you are unsure which to specify, send the specification clause or the consultant's comment and we will tell you which standard the mill can certify to without a special run.

Related

Send the specification clause

We will confirm which standard the mill certifies to and quote against it.

Request a quote